当前位置:首页 > 新闻中心 > 行业动态行业动态

亚克力板折弯是怎么做到的?

亚克力板怎么折弯:

下面是我们根据市场相关人事 调查都到的结果。
 
1.把电炉丝拉展,固定于工作台边缘,离桌面1CM高固定,把调压器接到炉丝俩边,调压从0V上升到70V时,炉丝发红,可以将折弯线对准炉丝,烤软折就行了。要想效果好,不跑线,最好先把折弯线踢槽
 
2.要圆角小就开槽!   要圆角大  就做模型。。。你折一个出来就知道咯
 
3.我们一般操作是把板子用鼓风烘箱将板材彻底烘软,温度达到140℃至160℃即可成型。 
一般的亚克力板即可造圆弧。



Acrylic plate bending:
Below we according to market related personnel are to survey results.
1 the electric stove wire exhibition, fixed on the working table edge, away from the desktop 1CM high fixed, the regulator receives the furnace wire both sides, voltage from 0V up to 70V, a furnace wire redness, can be bent line alignment furnace wire, baked soft folding line. To effect is good, do not run the line, the best first the bending line play slot
2 small slotted to fillet! To round big model... You fold one out on the know.
3 of our general operation is put the board with blast oven will thoroughly drying soft sheet, the temperature reaches 140 to 160 DEG C can be formed.
Acrylic plate can generally make arc.

文章推荐:http://www.huashuaite.com/n1/